Touch-sensitive Motorised 100 mm Fader with 200 mm cable for Midas digital consoles High-endurance up to 1 million cycle lifetime Premium quality wiper fingers made from Palladium Silver-Copper alloy Touch-sensitive T-bar and sensor track High-precision 10 kΩ linear resistive...
Touch-sensitive Motorised 100 mm Fader with 200 mm cable for Midas digital consoles
High-endurance up to 1 million cycle lifetime
Premium quality wiper fingers made from Palladium Silver-Copper alloy
Touch-sensitive T-bar and sensor track
High-precision 10 kΩ linear resistive track
Long-life, industry-proven Mabuchi* motor
Replacement for Penny+ Giles* PGFM3200, Alps* K-Fader, etc.
The motorised fader shall be intended for use on digital audio mixing consoles and control centres as part of a linear position-sensing servo circuit.
The motorised fader shall have an operational lifetime of up to 1 million cycles.
The motorised fader shall have a 10 kΩ ± 20% linear law track with ± 2% linearity.
The motorised fader shall have 100 mm travel.
The motorised fader shall use wiper fingers manufactured from Palladium Silver-Copper alloy.
The motorised fader shall have a touch sensing track which is connected to a conductive T-Bar fixing via a set of wiper fingers.
The motorised fader shall use a Mabuchi FF-050SB-09250 motor.
The motorised fader shall have a cable loom of nominal length 200 mm, terminating in a 6-way Molex 22-01-2065 connector shell fitted with 08-50-0031 crimps.
The motorised fader shall have overall dimensions 150 mm length x 13 mm width x 47 mm high (5.9" x 0.5" x 1.9").
The motorised fader shall have M3 threaded pillar fixings on 120.0 mm (4.7") fixing centres.
The motorised fader shall be the MIDAS PRO FADER (200 mm) and no other alternative shall be acceptable.